Sentence examples for ml were filled from inspiring English sources

For the experiment, a set of beakers with immersion capacity of 250 ml were filled with 100 ml test solution of acid 1N HCl, H2SO4, and HNO3 concentration.

The aluminum pots with a capacity of 1000 mL were filled with 500 mL tap water and covered with their appropriate lids and heated to 105 °C in a drying cabinet for 2 h.

Three spherical phantoms with volumes of 0.03, 0.12 and 1.17 ml were filled with activity concentrations in the range of 7.7 10.2 MBq/ml of 111In (0.1 M HCl) to investigate partial volume effects and to calibrate the SPECT images.

The pans with a capacity of 300 mL were filled with 200 mL tap water and covered with microwave wrap and heated to 105 °C in a drying cabinet for 2 h.

French mini straws (0.25 mL) were filled with the extended semen samples, sealed with polyvinyl alcohol powder, kept for 3 h at 5 °C for equilibration and then stored in an automatic programmable freezer until the temperature of straws reached −145 °C followed by plunging the straws into liquid nitrogen (–196 °C).

2) Pitfall traps made of plastic containers (diameter = 9 cm, volume = 400 ml) were filled with approximately 130 ml of 96% isopropanol.

A small reactor with a volume of 785 mL was filled with ≈260g of Mg(NH3 6Cl2 yielding a bed density of 331 kg/m331

The solution of Zonyl8740 solution (100 ml) was filled in a stainless steel cylinder and was pressurized to 5 MPa using nitrogen.

For bulk density, a glass cylinder (25 ml) was filled to a specified volume with 40 mesh powder biochar, dried in an oven at 80 °C overnight.

After thorough cleaning and functionalization, the 4 × 4-mm ITO substrates were stuck onto a tube cap, and the aqueous Au NPs solution of 0.5 mL was filled in the tube.

CO2 was injected into the reactor and pressurized to the desired level where 2/3 of the reactor (~70 mL) was filled with an aqueous phase (brine or distilled water).