Sentence examples for medium ratio from inspiring English sources

The effective medium ratio of the metamaterial unit-cell is 7.44.

The effective medium ratio (λ0/p) for proposed resonators is compared with various other metamaterial resonators to indicate compact nature.

With the aim of determine the best initial graphite/liquid medium ratio that allows obtaining the highest graphene concentration, a series of dispersions with different amounts of graphite was prepared for each of the two organosilanes.

The test results showed that maximum volume of pico and nano bubbles, 65 75%, and minimum mean pico and nano bubble size, 150 240 nm, were achieved at the medium ratio of the diameter of outlet of the venturi-tube and diameter of throat (3 4), medium outlet angle (11 13°), high inlet angle (26 27°) and high ratio of the length of the throat and the diameter of throat (2.3 3).

Furthermore, when both clathrin dependent endocytosis and non-clathrin dependent endocytosis are equally inhibited (a medium ratio of clathrin to non-clathrin dependent endocytosis rate), the signal response of Smad2 phosphorylation is similar as the control (Figure 6E).

The inhibitors oligomycin, antimycin, and rotenone lowered the tissue to medium ratio of iodine, which reflects iodine uptake, and inhibited also oxygen uptake.

The specimens with low and medium ratios of reinforcement, in which small-diameter bars are used, demonstrated a higher load carrying capacity sustaining more deflections at mid-span before debonding of FRP sheets.

Cells were cultured in flasks with a volume-to-medium ratio of 5 1.

Uptake was expressed as the cell-to-medium ratio (μL/mg protein) obtained by dividing the uptake amount by the concentration of substrate in the transport buffer.

In L858R and E746-A750 del cells, the cell-to-medium ratio (CMR) of morpholino-[I]IPQA was about 60 65 at 60 minutes, which was ~1.6-fold higher than that of wild-type EGFR-transfected H1299 cells (Table 1).

PBMC-derived HMGB1 was efficiently removed by both adsorbents tested (243 versus 113 ng/mL adsorbent for Cellufine sulfate and PSDVB-16, respectively, for an initial concentration of 13.7 ng/mL and an adsorbent-to-medium ratio of 5 vol%, Figure 4(b)).