Sentence examples for maximum discrepancy between from inspiring English sources

The maximum discrepancy between the simulations and measurements is relatively small, corresponding to the expected uncertainty of the model and measurements.

First, for an arbitrary given quantizer, we analyze the maximum discrepancy between outputs of both the discrete-valued input n-D system connected with the quantizer and its corresponding continuous-valued input one.

For each data set, two independent runs were executed until the maximum discrepancy between the bi-partition was less than 0.1.

Following Lartillot et al (2009) recommendations, all effective sizes were greater than 200 and maximum discrepancy between chains was less than 0.1.

For each data set, two independent chains were run until the maximum discrepancy between bipartitions was <0.1 (minimum 75,000 generations).

It is important to note that although there are differences in the ACD placement, the maximum discrepancy between ray tracing approaches is 0.5D, which is the IOL power step and the variability in the procedure, as we have shown in Fig. 8.

The maximum discrepancies between the simulated and measured results are 0.14, 0.42 and 1.13 mV, respectively.

Maximum discrepancies between measured and predicted NO concentrations were between 5 and 7 ppm (∼50%).

Maximum discrepancies between the true and the effective hyperpolarizabilities are calculated as a function of the orientation parameter D, and it is shown that the relative difference may not exceed 40% for usual distribution functions of the tilt angle.

The proposed nonlinear coupled thermo-mechanical approach, accounting for geometry, material and contact nonlinearities, is validated against full-scale furnace test results of typical, commercially available, load-bearing drywall systems, achieving a very good qualitative and quantitative agreement; maximum discrepancies between the predicted and measured fire-resistance ratings do not exceed 2%.

The maximum discrepancies between the experimental and calibrated measurement values of resistance were less than 0.5%.