Sentence examples for only absorption from inspiring English sources

As a result not only absorption spectra were changed but Resonance Rayleigh Scattering (RRS), Second-order Scattering (SOS) and Frequency Doubling Scattering (FDS) intensities were greatly enhanced.

For the dyes used in LCD, not only absorption wavelengths and ε[1] but also thermal stability and solubility are important [4].

In the spectra of fluids, the only absorption observed is that near 2350 cm−1 (Fig. 4), which is assigned as the v3 antisymmetric stretching in the CO2 molecule (see Nowak et al. 2003, and references therein).

For the case with absorber bottom pinch conditions, it was found that the CO2 flux sign changes and desorption occurred when taking the evaporation and condensation effects into account, whereas, without these effects, only absorption was predicted.

The most intense absorption band in this region, located at 1062 cm−1, attributed to vibration band of C-O bond, is the only absorption band of PEG200 which is faintly visible in the FT-IR spectra of IOMNPS (Fig. 5a).

However, the dispersion state of Ag in this sample is probably suitable to enhance DSSC performance because of the following two reasons: (i) if the arrays were fully covered with Ag, dye molecules could not be adsorbed on TiO2; (ii) surface plasmon resonance of Ag nanoparticles shows not only absorption but also scattering of light, thus the bottom part of TNT arrays should not be coated with Ag.

Additionally, this study may explain previous biomonitoring reports of plasma BPA levels deemed impossible or incorrect based on assumptions about gut-only absorption.

Optical absorbances of samples BaWO4 and Bi2WO6 show only one absorption band, while NiWO4 shows four absorption bands.

The Ag-Au bimetallic nanostructures with an Au Ag molar ratio of 1 0.17 had only one absorption band in the 522 547-nm absorption range during the heating process.

Absorption values are expressed as wavenumbers (cm−1); only significant absorption bands are shown.

In these suggestions, each metallic resonator has only single absorption mode, and therefore, the design of the multiple-band absorption devices requires at least as many resonators as absorption peaks.