Sentence examples for mean wind loads from inspiring English sources

The non-linear part of wind pressure was considered to estimate the mean wind loads.

Computational fluid dynamics is employed to evaluate the mean wind loads on sun-tracking ground-mounted solar photovoltaic panel arrays.

The influence of Reynolds number on the mean wind loads acting on cylindrical roofs with different aspect ratios (rise to span ratio, R/D) has been investigated experimentally.

Finally, it is found that the effect of geometric scale of a model on the mean wind loads in the outburst region is minor when it is within a blockage ratio of 3% as tested in the present study.

Moreover, when a higher interfering building was located at (X/B, Y/B)=(1.5, 1), mean wind loads and fluctuating wind loads in the along-wind and across-wind directions simultaneously increased.

The ESWL is got by simple amplification of the mean wind load with a single parameter γ, but the γ used for the latitude and meridian directions are independent and the former is much larger.

Mean and fluctuating wind loads are measured on each building member and wind-induced dynamic responses of the building are estimated with the high-frequency force-balance technique.

The work describes the aeroelastic model construction and it is focused on the evaluation and analysis of the mean and peak wind loads at the tower foundation and the cable anchorages since these data can be very useful by the bridge manufacturer as a support for the bridge design.

In current practice, structural engineers commonly focus on the wind-resistant design by means of static wind loads.

Second, this paper investigates the envelope reconstruction problem targeting the efficient reconstruction of the envelope values of a set of non-Gaussian structural responses by means of principal static wind loads (PSWLs).

For hurricane-prone regions, assuming epistemic uncertainties are negligible, we estimate mean recurrence intervals (MRIs) of wind loads inducing the design strength, obtained from 50 yr loads via multiplication by a factor specified by the ASCE 7-95 Standard.