Ai Feedback
Exact(5)
Most of the high-pressure rocks that have been studied from Japan, California, New Caledonia, the Alps, and Scandinavia record maximum pressures of 10 20 kilobars, corresponding to subduction to depths of approximately 35 70 kilometres.
At the maximum pressures of two separate experiments (1.4 and 6.0 GPa, respectively), our results show that the absolute values of the applied strain determined using Eq.2for the nano-Ni are 3 4 times higher than those for the micron-Ni.
Calculated metamorphic phase diagrams based on garnet-staurolite-andalusite-bearing metapelites indicate a clockwise pressure temperature (P T) evolution involving decompression and heating from maximum pressures of 4 to 4.5 kbar at 530 °C to maximum temperatures of ∼570 °C at 3.5 kbar.
This compares with maximum pressures of approximately 846 mmHg, demonstrated with introduction of cement into the femoral canal in a dog model by Orsini et al. 1987).
However, since our equipment only allows for maximum pressures of 9 10 cm H2O, we called this mode of respiratory support n-BiPAP, even though higher inflation times (or time high [Thigh]) and lower rates are more commonly used in this treatment modality.
Similar(55)
This study presents experimental and simulated data obtained from a bench-scale PSA, with a maximum pressure of 6 bar for pressurization and feed steps and minimum of 1 bar for blowdown and purge steps.
The water cannons in question are Wasserwerfer 9000 models, with a maximum range of 65 metres throwing out 2200 litres of water a minute, or 37 litres a second, at a maximum pressure of 15 bar.
The accumulator, or nitrogen pressure tank, is about four feet long, with a volume of 20 liters, or about five gallons, and a maximum pressure of about 3,600 pounds per square inch.
The author, the French engineer Alphonse Beau de Rochas, laid down the following conditions as necessary for optimum efficiency: maximum cylinder volume with minimum cooling surface, maximum rapidity of expansion, maximum ratio of expansion, and maximum pressure of the ignited charge.
The fluidic interconnection endures maximum pressure of 115 ± 11 kPa.
The permeability tests show a maximum value of 3.5 cm3/cm2/s at the maximum pressure of 120 Pa.
Write better and faster with AI suggestions while staying true to your unique style.
Since I tried Ludwig back in 2017, I have been constantly using it in both editing and translation. Ever since, I suggest it to my translators at ProSciEditing.

Justyna Jupowicz-Kozak
CEO of Professional Science Editing for Scientists @ prosciediting.com