Sentence examples for maximum current in from inspiring English sources

The maximum current in the electrical straps is always within the halo current value, which was used to design the component.

The result showed that DSCs with an electric field applied during the dye-adsorption process reached the maximum current in 5 h, while conventional DSCs required 12 h.

It is shown that the maximum current in the transient is suppressed when hydrogen is evolved on hemispheroidal growth forms characterized by eccentricity values less than one, whereas it is accentuated for eccentricity values greater than one.

The peak value of the second anodic current loop as well as the ratio of the maximum current in reactivation loop to that in anodic loop (ir/ia) determined from the modified DL-EPR test were found to be an effective measure of the precipitation of α′-phase during the aging.

With a decrease in the sweep rate of cyclic voltammetry, the potential of the maximum current in the positive-going sweep decreases from 0.9 to 0.6 V, while that of the maximum HCOOB band intensity in the positive-going sweep is almost constant at approximately 0.9 V.

The photocurrent illuminated from the positive poled side corresponds to the absorption spectrum of PhCz, while the photocurrent from the negative poled side has maximum current in the absorption edge of PhCz and no photocurrent activity in the strong absorption region of PhCz below 330 nm.

The ratio of Ir (maximum current density in the reverse scan) and Ia (maximum current density in the anodic scan) was used to evaluate the DOS.

Above I c the junctions become dissipative, limiting the maximum current induced in the gradiometer and protecting the SQUID.

Maximum current speeds in both of these locations remain under 1 m/s for scenarios P75, NH80, P80, Toh2011 and Chi1960 but increase to 1.8 3.9 m/s for the 8.5 MW potential scenarios.

The electrochemical oxidation potential of ClC resulted to be linearly dependent on the pH with a maximum current intensity in acetic acid buffer solution under the conditions used.

For instance, at 10 wt% nickel content and 2 M ethanol concentration, the observed maximum current density in case of exploiting graphene, carbon nanofibers and carbon nanoparticles was 45, 67 and 9.5 mA/cm2, respectively.