Sentence examples for between the adhesive layer from inspiring English sources

Further comparison on failure modes confirms that the sufficient surface pretreatment can improve the bonding quality between the adhesive layer and the steel support.

With the validated FE model, three-dimensional nature of the stress distribution and stress singularity at the interface between the adhesive layer and the steel support are investigated.

The possible premature failure due to debonding between the adhesive layer and concrete is one of the key issues in FRP-strengthened RC beams; debonding can occur at the beam end (end debonding) or in the cracked zone (intermediate debonding).

Interfacial shear cracks were initiated between the adhesive layer and the stiffer-adherends at the joint-overlaps, whereas the adhesive layer remains attached to the lower stiffness adherend tip-ends.

In the matrix design, the drug is embedded either in the adhesive (drug-in-adhesive patches), or in a layer of matrix material between the adhesive layer and the backing.

The results indicate that though the stress distributions of a single-lap adhesively bonded joint are strongly affected by the boundary conditions of the joint, the stress concentrations are confined to a very small region near (or at) the free ends of interfaces between the adherend and the adhesive layer while the centre region of the adhesive layer is mostly stress-free.

More importantly, the thin and mesoporous TiO2 layer deposited on the bottom surface of TNTA makes it is possible to form mechanical interlocking between TNTA membrane and the adhesive layer to insure the excellent mechanical stability and efficient electron transfer from the TNTA membrane to the substrate.

The critical locations for the onset of the adhesion failure and the delamination induced damages have been found to be on the interfacial surfaces between the main adherend and the adhesive layer and on the surface between the first and second plies of the main adherend beneath the adhesive layer within the overlap region of the DLJ, respectively.

However a discrepancy is shown between the measured and predicted strains on the stiffener because of the adhesive layer between the plate and stiffener.

The adhesive layer between the host beam and the piezoelectric sensor patch is modeled as an elastic load transferring media.

The adhesive layer between the piezoelectric sensor and the host beam is also considered in this model.