Sentence examples for zone injection from inspiring English sources

Based on relative location of the cell signal to the defect area, the injection was determined as a border zone injection, if edges of both areas overlapped, as an infarct injection, if cell signal was completely surrounded by infarct area, or as a remote injection if cell signal was completely outside the infarct area.

(f) Homogeneous texture typically observed in the slipping zone showing injection structures (plane-polarized light).

Through research of gel rheological change under low-frequency vibration, vibration for a longtime in induction stage was found to be disadvantageous for forming the gel used in water channel plugging, but short-term vibrating could delay cross-linking and reduce resistance in near wellbore zone gel injection.

Figure 4 a, b show the pattern of label resulting from a small (160 μm diameter uptake zone) simulated injection of an anterograde tracer into this model.

This can be seen in Figure 4 e, f, which show the pattern of label following a larger (600 μm diameter uptake zone) simulated injection of a bidirectional tracer.

Thus, whereas the cell body counts obtained with this tracer cannot be considered as a complete representation of the numbers of cells projecting to the zone of injection, the percentage of cells found in each cortical area should still provide information concerning the proportion of inputs to FR from the diverse cortical areas.

These parameters include zones of injection and production (ZoIP), waterflood pattern (PoWF) and number/types of injectors and producers (NToW).

In so doing, the effect of zones of injection as well as production on the reservoir performance was analyzed.

In this section, the effect of zones of injection and production on the reservoir's primary depletion and waterflood performance was analyzed.

Waterflood was optimized using an approach that considered the zones of injection and production, the pattern of waterflood and the number and type of producers/injectors.

Waterflood was optimized using an approach that considered the zones of injection and production, the pattern of waterflood and the number and type of producers/injectors.  .