Sentence examples for zone can be calculated from inspiring English sources

Values of reservoir quality index, normalized porosity, and flow zone can be calculated by these equations.

The bottom boundary of the brittle zone can be calculated with Eq. (6).

Thickness (t) of each zone can be calculated using Eq. (34).

The radius of the nth Fresnel zone can be calculated as: F_{n} = sqrt{frac{n lambda d_{1} d_{2}}{d_{1} + d_{2}}}, (7).

Next, it is shown that the mechanical properties of the brittle deformation zones can be calculated by one of several methods, each of which has advantages and disadvantages.

The potential total number of climatic combinations (PTCC) that could be expected in the present world with 10 climate zones can be calculated with the formula: PTCC = ∑ i = 1 10 10 C i = 1 + 10 + 45 + 120 + 210 + 252 + 210 + 120 + 45 + 10 = 1023 In order to compare this potential number of climatic combinations with the observed frequencies in the South American mammals, we calculated a χ.

The expressions for kinetic parameters for a thin-zone reactor can be calculated using moments, and are much simpler than the expressions for a one-zone or a three-zone reactor.

Values of pore-grain ratio (φz) and flow zone index (FZI) can be calculated by the following equations; varphi_{text{z}} = frac{{varphi_{text{e}} }}{{1 - varphi_{text{e}} }} (7) {text{FZI}} = {{text{RQI}} mathord{left/ {vphantom {{text{RQI}} {left( {varphi_{text{z}} } right) }}} right.

Then, the total heat load to maintain the zone at specified temperature can be calculated as Q load = ∑ Q Out Ventilation + ∑ Q + External _ wall Tower ∑ Q + External _ wall Room ∑ Q ground Room + ∑ Q Window Room + ∑ Q Roof Tower + ∑ Q Roof Room + ∑ Q Side _ wall Chimney + ∑ Q Surface Chimney + ∑ Q People Light.

We hypothesize that these dynamics are driven by transfers of water through surface and lateral boundaries of transition zones, and that lateral transfers can be calculated from hydraulic gradients with external water tables at upper and lower boundaries.

According to recommendation of FLAC3D software manual, a zone apparent stiffness in vertical direction can be calculated by Eq. (22).