Sentence examples for wt I from inspiring English sources

The axi-symmetrical well flow simulation software WT (i) applies either analytical or numerical drawdown simulators in the formation, (ii) assumes uniform well bore drawdown conditions in the pumping wells, and (iii) considers drawdown driven induced flow in the observation well.

The thermal conductivity could be estimated from the following equation [13]: K = μ g C P,g + 10.4 / M wt, i Open image in new window (23).

We assume that the total number of wild-type allele reads and mutant allele reads in the i-th pool, denoted WT i and MU i, respectively, both follow a Poisson distribution with parameters λ WT i (x)= r(1− p i (x)) and λ MU i (x)= rp i (x), respectively.

Metabolic clearances (i.e., CLPM15 and CLPother) were scaled by the individual baseline body weight (WT i ) using an allometric model,, to account for the size of metabolizing organ(s).

The output of the HTS is the number of both the wild-type and mutant reads in each pool and is denoted y={ WT i, MU i } i =1 k.

Representative images (total of ×40 magnification) acquired from paraffin-embedded sections are illustrated in Figure  2 A. Picrosirius red staining shows that interstitial collagen staining was minimal in saline-treated WT (i) and P465L (iii) mice, whereas chronic administration of AngII induced a cardiac fibrotic response that was more severe in P465L (iv) mice.

Our strategy, based on TALENs, allowed us to introduce the P525L mutation in the endogenous FUS locus of the iPSC-WT I line.

Immunostaining, analyzed by confocal microscopy, showed that the iPSC-WT I line displays nuclear FUS localization both in the absence (Fig. 4A) and in the presence of ARS (Fig. 4B).

We also checked for the absence of mutations in the same genomic regions of the FUS and TDP-43 genes in the iPSC line derived from the control donor (iPSC-WT I; supplementary material Fig. S1E,F).

TNFα protein was not detectable at early intervals post-infection in either IL-1RI KO or WT mice (i.e. 12 and 18 h; results not shown).

The optimum hemp fabric content for these nanocomposites is 6.9 wt% (i.e. 6 fabric layers).