Sentence examples for within a tolerance range from inspiring English sources

A pin can be aligned within a tolerance range by an appropriate oscillating motion.

When the cursor was within a tolerance range of 2 mm around the center of the start circle for 500 ms, a tone (1000 Hz, 26 ms) was presented and the start circle was filled.

Apparently, in the MINP model, a tolerance range is associated with each measurement and an estimation value of state vector is chosen to maximize the number of estimated measurements that remain within tolerance [21].

It can be assumed that R. stricta is well adapted to its environment and the conditions it is normally exposed to, while extreme, are a daily occurrence that fall within its tolerance range.

Hence, if the simulated model contains two components that are close to each other in the sense that the difference between their locations is within the tolerance range, then we will combine them into a single peak.

The cross-machine alignment of PEDOT PSS and P3HT PCBM layers were shifted closer to the edge of ITO on the left side of the leaf although the deviations were within the specified tolerance range providing an acceptable alignment.

However, the RMSEs are within the tolerance range.

Pi represents the Performance Index that is the set of T and RH data falling within the tolerance range.

In arithmetic tolerancing it is assumed that the detail part dimension can have any value but within the tolerance range; whereas, in the statistical tolerancing scheme, it is assumed that detail part dimensions vary randomly according to a normal distribution, centered at the mid-point of the tolerance range and with its ±3σ spread covering the tolerance interval.

Evaluation of "upstart" different measurement values immediately after drilling was not performed, because all the values of hole diameters in the column "Immediately after drilling" were within the tolerance range of the corresponding cutting tool.

The spread of values in the column "Immediately after drilling" in repeated experiments is due to planned and unplanned replacement of the tools, having various actual sizes of the drill diameter being, however, within the tolerance range.