The phrase "within a tolerance of" is correct and usable in written English.
You can use this phrase when you are discussing acceptable limits or limits of acceptance. For example: "The measurements taken during the experiment must fall within a tolerance of plus or minus 3%."
The formation must maintain the relative spacecraft separations to within a tolerance of a few metres.
Secondly, the algorithm is guaranteed to give results within a tolerance of the global maximum, and this tolerance may be freely chosen by the analyst.
All lens apertures have been milled employing a focused ion beam and could thus be precisely aligned within a tolerance of about 300 nm from the optical axis.
They are equipped with an electric heater system, with which the temperatures in the specimens stack can be kept at temperature levels between 250 and 650 °C within a tolerance of 30 °C.
(b) Place the metal block on the hotplate or heat the metal block by other suitable means so that its temperature, as indicated by the thermometer placed in the metal block, is maintained at the specified temperature within a tolerance of ±1 °C.
For cattle grazing green pasture in a low-noise environment with a Lavalier microphone positioned on the forehead, the system achieved 94% correct identification (i.e., aural events matched by software events within a tolerance of 0.2 s) and a false positive rate (i.e., software events not similarly matched by aural events) of 7%.
HME3M then attempts to compensate for this lack of variation within the pathways observed at a tolerance of 0.1 by overfitting.
When the cursor was within a tolerance range of 2 mm around the center of the start circle for 500 ms, a tone (1000 Hz, 26 ms) was presented and the start circle was filled.
While that would be higher than the government's year-end target of 5.5percentt, it would still be within a tolerance band of 2.5 percentage points.
To guarantee successful induction therapy, after the first n1 doses are taken, we will force the lower endpoint of the drug concentration to be within a tolerance ε1 of the impulsive orbit.
The performance of the apex locator showed similar reliability obtained in previous Studies [ 10, 17- 21] in both tested methods in correlation to apical extent of root canal filling to the radiographic apex within a tolerance level of ± 0.5 mm from radiographic apex.
