In case of preincubation with antagonist, the solution of compounds 1 was added first, the plate was incubated for 1 h, then the cells were stimulated with E. coli O111 LPS and the plate was incubated for 20 24h.
The sample was adjusted to pH 6 with 0.1 N HCl, and the solution of AlCl3 was added to get a final concentration of 0.0005 M of AlCl3.
If the tissue does not dislodge from the cap, you can use the vortexer with the solution added to force it out of the cap, or carefully pull it with a clean spatula.
With constant magnetic stirring, the solution of Mg(NO3 2·6H2O was added dropwise to the above solution at 50°C through a dropping funnel.
For primer extension with immobilized strands, 5 μL of the solution was added to 25 μg of magnetic beads, loaded with the primer template complex 14 and then used to dissolve the downstream-binding strand (5 nmol).
BSA-loaded NPs were formulated similarly to that mentioned above with a slight modification of adding the BSA solution (20 mg of BSA in 200 μL of deionized water) into the polymer solution for NP fabrication.
At 40 min after the injection of sulfur precursor, the solution with InP QDs and sulfur precursor was heated to 200 °C and then the solution was added with 4 mL of zinc precursor.
Streptavidin horseradish peroxidase (Jackson ImmunoResearch Laboratories, Cambridgeshire, UK) was then added with the substrate solution of 3,3′,5,5′-tetramethylbenzidine 3,3′,5,5′-tetramethylbenzidine
The solutions were prepared starting with 2 mL of BMSF solution and adding the calculated volumes of the other components.
After incubation of the cells with the substances, 10 μL of the MTT solution was added to each well of 96-well plates and incubated for 3 h at 37°C in humidified atmosphere of 5% CO2.
