Sentence examples for with the half width from inspiring English sources

As-prepared microwires exhibit quite sharp voltage peaks induced in the pick-up coil associated with fast magnetization switching with the half width of the peak about 3 μs.

Although cross-correlation of many ganglion cells with full-field flicker show a peak with 0 ms (nominal) synchrony, the half-width of the correlation is commonly in the range of 20 ms [ 19].

As observed for the 2Cys47 unfolded peak, the apparent spFRET peak efficiency for the 2Cys313 unfolded peak decreases with increasing GdmCl concentrations, and the half-widths are wider than those predicted from shot noise.

In three of nine neurons, the half-width increased with stimulus intensity.

With 60 subjects per treatment group, the half-width of the 95% CI for the difference between treatment groups was estimated to be 2 to 3 days.

The point spread function (PSF) for deconvolution was generated by using a 2D Lorentz function with its half-width and half-length fitted to the half-width and half-length of each individual image.

For the treatment cohort, the sample size target of 22 patients per treatment group was chosen to allow for the calculation of 95% CI for the primary end point with a half-width of 0.42% for each treatment group, assuming a 1% SD; the half-width of a 95% CI for differences between mean treatment changes was estimated to be 0.59%.

The obtained spectra are then smoothed by computing the mean with half width of five points using the subroutine "smooth" in the Seismic Analysis Code (Goldstein et al., 2003).

The case with half width filleted slot achieves a higher film cooling level at most areas of the endwall than that of the case with half width sharp-edged slot, except the vane leading edge-endwall junction region.

In Eq. (3), the intensity peak increases along with a reduction in the peak half width indicating the growth of ITO-NPs.

The analytical solutions of the mode I stress intensity factor based on the solutions for infinite and finite square plates with an inclusion are compared with the results of the three-dimensional finite element computations of lap-shear specimens with various ratios of the specimen half width to the nugget radius.