Sentence examples for with increasing drift from inspiring English sources

Based on the calibrated models a study was conducted on the timber frame wall with brick infill model by varying wall configuration and analysing cumulative energy dissipation and the effect of slenderness and load capacity with increasing drift.

Controlling the axial elongation at the top of the wall results for walls subjected to a small axial load ratio in an increase and for walls subjected to a large axial load ratio in a decrease in axial load with increasing drift demands.

Both Rd and Rp increase with increasing drift length, driving efforts to extend the drift cell length to increase resolving power.

In the negative direction, as shown in Fig. 18a, the strains of the test specimens increased with the increasing drift ratio and did not show significant difference.

First, at a drift level of 1.0%, flexural cracks appeared in the beam; with the increasing drift level, numerous flexural cracks newly developed but the crack width was significantly narrower than that of J-0.

In general, the stiffness of the test specimens decreased with the increasing drift ratio; such degradation is attributed to the development of flexural and shear cracking in the beams and in the joint panel zones.

When the equivalent results for the three test zones are considered in isolation (Table 4), there is a general trend of increasing integration, with increasing area and increasing drift, but the correlation is not linear.

(a ) Drift-plots show that mianserin attenuates increasing drift-variance with age.

(g ) Drift-plots show daf-2 RNAi attenuates increasing drift-variance with age in a manner dependent on daf-16.

A total of five specimens were cast and tested: a control specimen was punched without eccentricity, one specimen was tested under constant vertical loading and monotonically increased eccentricity until failure and the remaining three were tested under constant vertical load, at different shear ratios, and cyclic horizontal loading with increasing horizontal drift ratios.

The higher stress at the column base caused flexural cracking started at the early stages of loading and the number of flexural cracks increased and propagated with increasing in drift ratios.