Sentence examples for with a bandwidth of zero from inspiring English sources

State '0' is assumed to be associated with a bandwidth of zero, delay of 500 ms, and BER and Jitter of zero values.

We consider the following scenario: OFDM spatial interference alignment transmissions in the 3-user MIMO interference channel with two antennas per transmit/receive node; a single data stream per user; a wireless local area network in indoor environments; and the IEEE 802.11a waveform — with a bandwidth of 20 MHz — for the three users.

Each spectrum was signal-averaged at least two times with a bandwidth of 1.0 nm and resolution of 0.2 nm, at a scan speed of 20 nm/min.

With a bandwidth of 10, the estimates are very close to zero and statistically insignificant.

For our simulations presented in this article, we selected four test scenarios with a bandwidth of 10 MHz but different transmit modes (single antenna port transmission, OLSM, and TxD), different AMC schemes, and different channel models.

Each spectrum represents an average of three scans performed at 50 nm/min with a bandwidth of 1 nm.

Five triaxial piezoelectric accelerometers with a bandwidth of 240 Hz (VR001, Midé Technology) were installed on the wheelchairs as shown in Figure 1 and were sampled at 3200 Hz.

Eight scans were acquired over the range 200 260 nm with a bandwidth of 1.0 nm and a scan speed of 20 nm min 1 and then averaged.

In this study, we selected two excitation wavelengths using a filter (Chroma, HQ565/30) centered at 565 nm with a bandwidth of 30 nm and another filter (Chroma, HQ530/30) centered at 530 nm with a bandwidth of 30 nm, respectively.

Data were obtained from 190 320 nm at 0.5 nm intervals with a bandwidth of 1 nm.

All recordings were performed with a bandwidth of 0.01 KHz to 10 KHz.