Furthermore, without the much knowledge on the antenna, initially no wire was connected to the wire end of the chip.
It is believed that the wire end is the starting point.
end{aligned}Position of wire end points on the top plate w.r.t the top plate coordinate: begin{aligned} left.
end{aligned}The positions of wire end points on the top plate w.r.t the top plate coordinate are given by: begin{aligned} left.
The DAMs are arranged on the frame such that the positions of the wire end points on the frame are as shown below: begin{aligned}left.
The DAMs are arranged on the frame such that the positions of the wire end points on the frame are as below: begin{aligned} left.
Cross-Connect Box Technically called a "Feeder Distribution Interface" box, these wires end up in a box known as a cross-connect.
The free wire end was capped with insulation and both sides of the incision were tied off with surgical thread to prevent fluid infiltration into the insulation.
Remove about 1 inch (2.5 cm) of insulation from each wire end.
Tip: Keep the wire end going inside the ring and gradually tighten.
