Sentence examples for wire was reduced from inspiring English sources

The gap between aluminium connector terminal and copper wire was reduced by 70% than conventional process.

The reflector voltage was reduced in 25% steps and guide wire was reduced 0.02 0.01% with an extraction delay time of 100 ns.

To enhance operating speed and reduce power consumption, the voltage swing on the wire is reduced using current-mode scheme.

In other words, when the part radius is low and part height is large, the stiffness of the wire is reduced and the error of the part sharply increases.

The wiring (an electrical feed through) is formed using the lift-off method and running on the SiO2 film surface from the heater element to the bonding pad through the SiO2-wiring bridges; in this way, the amount of heat transferred to the wiring is reduced.

The quasiparticle GW band gaps of the atomic wires are reduced by ∼1 eV when supported by a graphene substrate.

The chip was mounted on a glass epoxy substrate with the diameter of 19 mm using flip-chip connections so that the cross talk due to wiring is reduced as small as possible.

To better understanding the role of EPS in the emergent transport behaviors of manganite one-dimensional structures, some manganite wires are also fabricated from single thin film by optical lithography, where the width of the manganite wires is reduced to a scale on the order of the inherent phase separation.

For example, to understand the role of electronic phase separation (EPS) in the emergent transport behaviors of one-dimensional manganite structures, La0.33Pr0.34Ca0.33MnO3 (LPCMO) nanowires were fabricated from a single-crystalline LPCMO thin film via optical lithography, where the width of the manganite wires is reduced to a scale on the order of the inherent phase separation [24].

Compared with the randomly optimized method, on average, our approaches reduce the maximum package density by 42% and 68% for both technologies, IR-drop by 10.61% and 4.58%; and the bonding wires is reduced by 15.66% if we use stacking chips.

This ensured that any bias related to position of wires related to the surgeons experience with wire insertion was reduced.