Sentence examples for wire surface is from inspiring English sources

In the current research, however, the bismuth nanowires were covered with a quartz template; therefore, oxidation of the wire surface is prevented.

But there are still some shortcomings: Due to the limited conditions, when the rigid-flexible coupling dynamic model of pantograph catenary system is being established, the stochastic excitation of the contact wire surface is not taken into account.

The morphology of the prepared TNT-Ti wires was characterised by SEM and is summarised in Figure 2. A low-resolution SEM image of the wire surface is presented in Figure 2a and an image of the whole TNT-Ti wire (25 mm) is presented in Figure 2b, confirming the radial growth of TNT film on the Ti wire.

When the angle between the orientation of incident light and the normal of Pt wire surface is larger than 45°, the incident light can be reflect by Pt wire to the surface of photoanode, which is about 5% of the whole incident light.

The methods of cleaning of tungsten wire surface are reviewed with the aim of increasing reemitted positron yield from moderator wires.

The steel wire surface was cleaned using plasma generated in the CPE process and the Zn coating was found to accumulate during the rise in the power pulse.

Microscopic study of wire surfaces was performed using a scanning electron microscope JSM-840 (JEOL, Japan).

Furthermore, a driving force on each wire spacer surface is closely related to the relative position between the hexagonal duct wall and the wire spacer.

In Figure 4a, which presents the appearance of the non-heated tungsten wire surface, it is shown that a 2-nm-thick amorphous layer was coated perfectly on the surface of the tungsten wire.

To capture the shielding effects between discharge wires in a multi-wire ESP, the corona-discharge-induced space charge density at an arbitrary point between the discharge wire and grounded plates is specified as the sum of two components: (i) a uniform value on the wire surface which is resolved individually for each wire; and (ii) a space-dependent variation relative to the uniform part.

The effectiveness of vibration control methods, such as increasing damping ratio and twining spiral wire on the cable surface, is finally investigated.