Sentence examples for wire rate from inspiring English sources

The authors reported a fibrous union rate of 7.1%, a nonunion rate of 5.3%, and a ruptured wire rate of 17.8%.

The objective of the present work is to investigate the effects of various WEDM process parameters such as pulse on time, pulse off time, servo voltage and wire feed rate on the Material Removal Rate (MRR), Surface Roughness (SR) and cutting rate.

In WEDM, wire feed rate should be kept at low value to minimize the machining cost.

The input parameters considered are welding current, workpiece thickness, voltage and wire feed rate.

Therefore, it is desirable to set proper wire feed rate for stable machining with no or less wire breakage occurs.

Then, the input parameters are considered here including welding speed, wire speed rate, and gap with 5 levels.

It may increase for larger deviation of wire feed rate movement due to higher cutting speed and faster number spark generation from the new surface of the wire.

Therefore, a constant value of 5 m/min has been assigned to wire feed rate with adequate value of 10 N of wire tension.

Next, the module queried the ADAP table to get the proper welding parameters, i.e., weld current and wire feed rate.

The increase in the wire feed rate is from 2 to 6 m/min; there is not much difference in MRR observed.

An adaptive software was employed that calculated the wire feed rate according to the variation in the gap and the weld area.