Sentence examples for width which can be from inspiring English sources

It is shown that strained devices present higher noise than conventional ones, independent on the fin width, which can be explained by poorer interface quality observed in strained devices.

We have also demonstrated the ability of the STM to define MoS2 nanoribbons down to 12 nm width, which can be used as building blocks for future nanoelectronic devices.

Step 2. The (sigma) is the centre width, which can be obtained from sigma_{i} = frac{{c_{hbox{max} } }}{{sqrt {2h} }}quad i = 1,2, ldots,h, (3)where (c_{hbox{max} }) is the maximum distance between the centres of the hidden units.

The cubic law assumes that the average flow rate of a fracture is proportional to the cube of aperture width, which can be derived from the Navier-Stokes dynamic equation and is formulated as shown in Equations 2 and 3, based on the following three assumptions: Q ΔH = C · b 3 (2) C = g 12 v · w l (3) 1) The flow is constant and of the Hagen-Poiseuille type.

Developing a cheap fabrication methodology to realize dimers or trimers with the proper nanogap width, which can be as low as 10 nm, is extremely challenging.

Automated analysis requires no user intervention after setting the desired parameters whereas semi-automated analysis pauses after each image has been analysed to allow manual adjustment of identified blade dimension centre lines (i.e. length and width), which can be important where leaves are not perpendicular to the image plane.

In practice, there is one point of equal PSF widths (which can be set to be z = 0 nm), and PSFs originating from above or below are spread to a horizontal or vertical line, respectively.

One important feature of the proposed procedures is that the corrosion effects can be determined based on the width of corrosion cracks which can be easily determined in real situations.

The generated water waves are free to propagate both offshore and alongshore, since the plan dimensions of the used wave tank are of at least one order of magnitude larger than the width of the landslide, which can be considered to be a scale of the wave length.

Using ZEP-520A and poly(dimethylglutarimide) (PMGI) resists, we fabricated pillars having a diameter of 150 nm sitting on ridges having a width of 1.5 μm, which can be used to create via-holes and trenches for IC interconnect by nanoimprint lithography.

It is found that the length of transient regime is directly correlated with the extension of the initial scaled PSD toward the large particle size region, i.e. the so called tail, rather than the width of scaled PSD which can be described in terms of standard deviation.