Sentence examples for width of the load from inspiring English sources

Rocco et al. (2001) concluded that the load bearing strip as recommended by the ASTM standard seem to be too wide, however it was found that if the width of the load bearing strip approaches zero then size effects vanish.

When studying the influence of the gap width of the load and non-load cruciform welded joints, it is assumed that the gap width is 0 2 mm [17].

The transport tracks reduced the overall width of the load and could be used to drive the tank short distances on firm ground.

The thickness and the width of the loading-strip are crucial parameters.

Extending loading gauge is generally costly, especially the height at tunnels or bridges, yet in Sweden the width of the loading gauge on many lines has been extended at small cost.

From the power calculations (Fig. 5a), one can clearly see that the confinement increases with the width of the loading-strip and reaches a maximum for t p ≈ 250 nm.

The results show that the circumferential width of the applied load and the pressure distribution both strongly affect the form and magnitude of the stresses produced in the silo wall.

And, it is found that the effect of the width of patch loading on the nondimensional interaction curves of bending and patch loading and the interactive curves of shear and patch loading is small.

Using position-resolved scanning small angle X-ray scattering (SAXS), we quantified the degree and direction of mineral nanocrystallite alignment over the width of the scapulae, from the load bearing lateral border (LB) regions to the intermediate infraspinous fossa (IF) tissue.

The effect of the width-to-height ratio of the plate and the width of patch loading on the interactive curves are analyzed in detail.

Half of the width of distributed load for split tension cube specimen.