Sentence examples for width of flow from inspiring English sources

The rib width of flow field plates was varied from 0.5 to 3 mm.

In this paper, the effects of different Landing to Channel (LxC) width of flow channel were studied numerically.

Here I illustrate a refinement of currently-used flow-routing algorithms that yields unit contributing areas (i.e. contributing areas per unit width of flow) with minimal grid-resolution effects.

Last but not the least, this design, which decreased the width of flow path in conventional LF test strips from 4 to 1 mm, facilitates the enriching of analytes on the surface of the capture zone, improving the sensitivity under the condition of high flow rate.

From Table 2, the width of flow image is 120 pixels, and we have set the velocity interrogation window to a 3 by 3 pixels frame.

Both simulation and experimental results showed that relatively small widths of flow channels and ribs, together with a small ratio of the rib's width versus channel's width, are preferred for obtaining high power densities.

In order to calculate the flow rate to apply physiological shear stress we used Eq. 1 as mentioned below where Q is desired flow rate, Τ is the target shear stress, µ is the viscosity of the flow medium, w is width of the flow chamber, and h is the height of the flow chamber (Bhat et al. 1998).

This study emphasized the effect of rib and channel width geometry of flow fields by symmetrical mode of fuel cell operation using electrochemical impedance spectroscopy to obtain the anodic and cathodic mass transfer resistance individually.

At unit Péclet number (based upon width of the flow channels) the resulting selectivity curves are found to be in remarkably close quantitative agreement with those for plug flow, despite major differences in the inner solute concentration profiles a feature that does not persist at significantly higher Péclet numbers.

The width of the flow channel is Lc and that of the channel walls/ribs is Lr.

The optimal total width of a flow channel and its wall/rib as well as the ratio of a rib against total width, were investigated for higher power density.