Sentence examples for width boundary from inspiring English sources

In the middle and late production periods, it is unidirectional flow in the distant wellbore area after pressure waves reach sand-body width boundary.  .

In the early production period, it is radical flow in the near well area before pressure waves reach sand-body width boundary.

Concerning the present SuperDARN observations, the spectral width boundary around ~77°, MLAT is a good proxy for the open/closed-field line boundary, especially when the SuperDARN radar is located around the geomagnetic local noon sector (Chisham et al. 2007).

The sand-body scale of Sulige Gas Field is small, so when pressure spreads to the width boundary it does not obey the seepage rules of pure radical flow, as shown in Fig. 2.

It was previously shown that for moderately disturbed conditions in the pre-midnight sector, the location of the spectral width boundary (SWB) corresponds to the poleward edge of the auroral oval, as determined from energy spectra of precipitating particles measured on board Defense Meteorology Satellite Program satellites.

We provide numerical values for boundary positions, domain widths, boundary shifts, and domain overlaps between M. abdita and D. melanogaster in Supplementary file 2A D.

On the microscale, observed by TEM, the degree of misorientation among subgrains/cells increases and the width of boundaries decreases while the cell/subgrain size remains approximately constant as the number of passes increases.

κ of GNMs is found to be even up to 200-fold lower than the graphene nanoribbons (GNR), a potential thermoelectric material, of the same neck width and boundary-to-area ratio.

This helps to restrict the width of the boundary population to few (two-three) cells and contributes to polarizing ligand-receptor signaling towards the boundary and not against it, i.e. flanking ligands signal Notch towards the boundary but not against it since down-regulation of the Notch pathway in non-boundary cells inhibits the receptors' activity in those cells.

Since the grain boundaries width is close to the limit of the AFM resolution, environmental conditions can be the determinant factors to precisely correlate the leakage spots position with the morphological structure of the high-k dielectric.

With heating of the substrate, densification occurs, and the grain wall boundary width is thinned.