Sentence examples for while fabricating from inspiring English sources

While fabricating glass equipment for use in the chemical industry, he became increasingly fascinated by the tradition of South Jersey glassmaking and its "crown jewel," the paperweight.

The investigators also located two safe houses that they believe were used by the bombers and evidence that they had lived in at least one of the houses while fabricating the bomb.

Mr. Kharit paused to encourage a sculptor who was consulting a coffee table book on St . Petersburgs imperial palace parks while fabricating a model of entwined women on a pillar capital.

The T-NT synthesized per the method presented here generates nanotubes that are isolated from the substrate, which could prove advantageous while fabricating T-NT-based T-NT-based T-NT-based

Significant different channel dopant distribution can be easily obtained while fabricating sub-0.12 μm devices in the partially depleted SOI substrate, due to the buried oxide layer.

Summarizing, this review highlights the need to adopt intelligent processing approaches and targeted application-specific biocompatibility characterization, while fabricating mechanically stable and biologically functionalized 3D tissue equivalents.

Technology features of composite synthesis and device fabrication, which should be taken into account while designing and fabricating sensors based on metal oxide composites, are considered.

However, raw materials have declined as a percentage of Canada's exports, while processed, fabricated, and manufactured goods have increased.

With the same thickness of zeolite layer, nanoZMEs prepared by the LbL technique possess short preconcentration and response time, while nanoZMEs fabricated through the secondary growth method exhibit high accumulation ability and ion exchange selectivity.

While the fabricated PZT cantilever exhibited large angular displacement of approximately 2.29° with radius of curvature of 4.16 mm due to its residual stress, the angular misalignments were within 0.28° and 0.13° for the horizontal mirrors with area of 150 ×150 μ m2 and 250 ×250 μ m2, respectively, due to the use of two supporting cantilevers.

The Gd layer obtained at Vb = 150 V had a strong preferred (110) orientation and a dense structure with the highest residual stress (− 5.8 GPa) and argon content (∼ 3 at.%), while layers fabricated under zero bias or under Vb = 450 V had a strong preferred (002) orientation and a less dense structure with lower stress (≤ − 2 GPa) and lower argon content (∼ 0.5 1 at.%).