The results give the instantaneous moduli of the solutions which are well compared with the rubbery plateau moduli from viscoelastic measurements, and the friction coefficients which are identical for both solvents when compared at comparable polymer concentrations.
The values of the N-terminal cleavage rate constants for the various inteins are comparable when compared at the same temperature in the presence of 50 mM DTT (Table 4).
The gasification reactivity of the coke was found to be 120 16 of the char when compared at 1200∘C.
However, they are much lower than stirred reactors when compared at the same power consumption per unit mass.
When compared at the same tensile strength, ΔKth tends to be larger for composites than for unreinforced alloys.
The SCABA 6SRGT is shown to have an almost identical pumping rate to a disc turbine, when compared at the same diameter and specific power.
The elastic moduli (G′) of the toluene/clay dispersions for all three clays were similar when compared at equal inorganic content.
As the formulation glucose concentration was raised, a graded decrease in storage modulus, loss modulus and complex viscosity when compared at 1 Hz was observed.
However, the stress-strain relationship in tensile deformation clearly depends on the formation pathway when compared at the same crosslinking density.
Moreover, when compared at the same Re or Dn, the heat transfer coefficient increases by increasing the coil diameter and nanoparticles volume concentration.
As a consequence, the fraction of flipping phenylene rings in the liquid crystalline state is larger than in the isotropic state, when compared at the same temperature.
