Sentence examples for wheel radial from inspiring English sources
Open image in new window Fig. 10 Load variation regularity of each wheel in the bogie, a guide wheel radial force, b steady wheel radial force, c walking wheel radial force, d walking wheel cornering force.
Open image in new window Fig. 9 Calculation results of curves with different radii, a carbody rolling angle, b guide wheel radial force, c steady wheel radial force, d walking wheel lateral force.
When a vehicle runs through a curve with a small radius, the orbital superelevation and running speed both have significant influences on its passing-through performance [5, 6]. Figure 9 shows the maximum value of carbody rolling angle, the maximum value of guide wheel radial force and the maximum value of steady wheel radial force, when the vehicle passes through curves with different radii.
Early vertical-shaft water mills drove querns where the wheel, containing radial vanes or paddles and rotating in a horizontal plane, could be lowered into the stream.
This paper shows enhancement of knowledge about magnetic flux density of automotive wheels with radial pneumatic tires equipped with ferromagnetic belt made of tangled steel wires.
By converting the vertical stiffness of spring on the tumbler of guide wheels into the radial stiffness of guide wheel, the equivalent radial stiffness of guide wheel K g can be obtained.
The device then spins a motorized radial wheel for a minute to remove a microscopic layer of plastic from the playside which should remove surface scratches.
Both tangential and normal wheel rail contact forces as well as axial and radial wheel dynamics are taken into account.
In particular, the influence of the radial wheel eigenmodes with two or three nodal diameters is significant.
The origin of fatigue failure that occurs on the air ventilation holes of a newly designed heavy commercial vehicle steel wheel in dynamic radial fatigue tests is studied.
The feed speed of the grinding wheel in the radial direction is modified according to the cross-section of the groove that passes through the centre of the cutter sphere.
