Sentence examples for wet operation from inspiring English sources

These correlations are compared to corresponding equations from literature, revealing significant deviations for wet operation but smaller differences for dry operation.

The thermal performance and heat and mass transfer coefficients are determined from the experimental data by means of an Effectiveness-NTU model, which for wet operation applies the Merkel assumptions (Lewis factor, Lef = 1 and negligible evaporation loss).

The new fin surface design was also shown to decrease the air-side core pressure drop of the prototype heat exchangers during wet operation by an average of 30 36 percent over the baseline heat exchanger, with the actual percentage strongly dependent on the flow rate.

Know that bathing a baby can be a wet operation and be prepared to find a change of clothes afterward.

New empirical relations are presented for the heat and mass transfer coefficients for wet-operation, Nusselt number for dry operation and air-side loss coefficient for wet and dry operation.

The critical wet milling operation parameters were i.e., drug concentration, drug-to-stabilizer ratio, stabilizer type (HPMC E15 or Tween 80) and milling intensity.

The council would not respond to the comments but said its wet weather operation had moved into the "recovery phase", with the Met Office saying the worst of the weather was moving away from Cornwall.

Air Europe's holding company bought a third of Norway Airlines in October 1989; this allowed the Norwegian company to start flying Air Europe's route between Oslo and Gatwick as a wet lease operation, in addition to several international destinations from London.

In 2001, Menu bought the wet food operations of Doane Pet Care, a major contract producer of dry foods in the United States, for $15 million.

Textile industry uses large volumes of water in wet processing operations resulting in generation of substantial quantities of wastewater which contain large amount of dyestuff.

Results derived from the theory are within reasonable agreement with reported data for dry and wet grinding operations, although minor variations are observed between theory and experiment.