Sentence examples for wet injection from inspiring English sources

The study has included the evaluation of the separate influence of intermediate gas superheat, intermediate pressure and wet injection.

Comparison of the results indicates the highly significant influence of preceding hydrological conditions (dry vs wet), injection mode (artificial flushing vs natural infiltration by subsequent rainfall, and on a bare rock vs on an overlying layer) and geologic heterogeneities within the vadose zone on solute transport in the karst vadose zone.

Inadequate contact between injector and the skin has been reported to result in bruises and "wet" injections, leading to discomfort and unpredictable insulin absorption profiles (21).

Ehrlich et al. (1984) reported a change of initially water-wet cores to nonwater-wet condition after injection of CO2 Water-alternating-gas (WAG) to obtain residual oil saturation.

As the sand pack is water-wet in general, injection of the surfactant solution can recover more oil from the oil-saturated core during surfactant flooding by alteration of wettability toward a water-wet state.

A mathematical model for predicting bubble growth, bubble volume, bubble shape and frequency of bubbling for bottom gas injection in wetting and non-wetting liquids is presented.

The presence of ZnO, deliberately formed through the injection of wet HNx into the snout was observed within the arrowhead defect and can be identified as the root cause of this defect.

Whilst the injection of wet HNx as a method of suppressing the formation of zinc vapour is a long standing process for automotive Full Finish production, due to the nature of these oxide-based defects, this process is in fact a "double edged sword" in that it solves one problem but can create another.

On the other hand, in situ combustion, steam injection and wet combustion methods are grouped into thermal processes (Leung et al. 1985; Sharma and Shah 1985; Auvray et al. 1984; Scriven 1976).

The resin transfer mould filling process has significant effects on different aspects, such as fibre wetting out and impregnation, injection gate design, "dry patch" and void formation.

The wetted width and the injection pressure for a given liquid flux decrease with the increase in the hydraulic conductivity of the waste.