Sentence examples for were observable with from inspiring English sources

The location was chosen such that both LOS and multipath signals were observable with LOS being stronger than multipath signals.

Above 783 K, the ferrite phase consisted of coarse recrystallized grains which were observable with optical microscopy and ultrafine unrecrystallized grains.

It was also remarkable to recognize that even in a lower frequency regime, for instance from 0.1 Hz up to 200 Hz, the spectral peaks in the dispersion curves of the dielectric loss factors were observable with separate consecutive relaxation times.

Unambiguous hg H/non-hg H assignments of pure samples as well as detection of a 1∶1 hg H/non-hg H mixture (200,000 mtGE each/reaction) were possible up to 30 µM hematin, whereas at higher inhibitor concentrations no (60 µM) or only very weak melt-peaks (45 µM hematin) were observable with 32 cycle ARMS-DCA (Figure 8).

Six days after plating, nonadherent spherical clusters of cells were observable with different morphologic phenotypes similar to spheroids isolated from human primary tumor tissues and cell lines [ 15, 16, 19].

Since FGF and BMPs differ in the way they form signaling competent dimers, the biphasic response that can be observed with FGF may not be observable with BMPs or other growth factors [ 48].

DET curves of the combination of each system are also shown in Figure 2. It is observed that the relative improvement of language recognition performance is observable with our proposed approaches.

Comprehensive simulation results show that absolute states of the surface assets are observable with an achieved accuracy of the position estimate on the order of tens of meters.

In parallel, a reduction in the leukocyte adhesion to both pristine PPy-coated and PPy-HEP-coated fibers was observable with AC stimulation.

The reduction of motion artefacts was observable with the BLADE technique despite the systematic use of a spasmolytic agent in our clinical set-up, demonstrating BLADE's effectiveness.

Such changes in conductivity would not be observable with bulk samples because the surface-to-volume ratio is much smaller for bulk samples, and the conducting paths through the bulk would drown out any changes due to surface modification.