Sentence examples for weight of the mixture from inspiring English sources

Another formulation is derived to determine the molecular weight of the mixture from classical thermodynamics.

Tyrosine, an amino acid comprising about 1 to 6 percent by weight of the mixture obtained by hydrolysis of most proteins.

A simple version of the model is also developed without solving the governing equation for the molecular weight of the mixture.

Unconfined compression tests have been conducted to measure the strength parameters considered in the mixtures of soil+bottom ash for which the bottom ash dosages were 0, 5, 10, 15, 20, 25, and 30% by dry weight of the mixture.

The governing equations in conservative form are further derived to calculate the specific heats ratio and the molecular weight of the mixture with their new formulations and the continuity or mass fraction equations for the individual components.

All block copolymers MePEG20-PCL800, MePEG60-PCL40, MePEG60-PCL40, MePEG80-PCL20) with different MePEG and PCL ratios were synthesized by adopting the above method by keeping the final weight of the mixture constant at 5 mg.

Table 1 Classification rates of the different CHMM structures of the single stream data Classifier Baum-Welch MCE BW and MCE Baseline CHMM 89.00 % 91.25 % 93.15 % MSCHMM L m 93.25 % 94.00 % 95.00 % MSCHMM L s 92.75 % 95.25 % 97.45 % Figure 1 Stream 1 relevance weights of the mixture components in all four states, learned by the MSCHMM Lm model for the single-stream sequential data.

These pleasantness intensity polynomial functions developed in Lawless (1977) for the mixture's constituents required odorant-specific adjustment of the weights, and the linear model describing the pleasantness of the mixture (PAB) required experimental adjustment of the weights of the mixture constituents (CA and CB).

The present report contains results on thermal conductivity, viscosity, and stability of three different specific surface areas (300, 500, and 750 m2/g) at different concentrations (by weight percentage) of the mixture of GNPs and distilled water as base fluid.

The total weight of the reaction mixture was 1,670 mg and it contained 50 mg of the cellulosic/hemicellulosic sample, 50 mg enzyme mixture (a 1 1 ratio of a mixture of Celluclast 1.5 L and Novozyme 188, both of which were obtained from Sigma-Aldrich) and 50 mM citrate buffer (pH 5.2).

The benefit of adding the nanotubes to a polymer before it is cast, says Someya, is that the nanotubes, which make up about 20percentt of the weight of the total mixture, are more evenly distributed.