Sentence examples for weight of suspensions from inspiring English sources

With the ability of fully supporting its own weight of suspensions during assembly, the scaffold fabrication requires no sacrificial support material or mould (Smay et al. 2002).

To reduce the weight of suspension coil springs for automobiles, high-strength steel has been developed.

It is observed that, the vehicle drifts towards one side due to high weight of suspension system.

This figure was thereafter adjusted for potential spillage and adhesion of suspension to the syringe walls and tip by adding one dose to the measured weight of the suspension in the bottle.

Suspension-cultured cells (10 mL) were inoculated into 50 mL of MS medium, and the dry weight of the suspension was determined to be approximately 40 mg.

That, in turn, allows the weight of the suspension system to be reduced by 25%.

It was confirmed with a Rheo-NMR system from Bruker that 10% by weight of Y2O3 suspension is a non-Newtonian fluid.

Moreover, the dry weight of the suspension-cultured cells slightly decreased with increasing concentrations of Cef.

Figure  5A shows that the dry weight of the suspension-cultured cells significantly decreased with increasing concentrations of Kan, and that the working Kan concentration of ~75 mg/L was most appropriate for this study.

Styrene grown cells were inoculated into the biostat in the amount which enabled the start of each culture at a similar concentration of cells in the solution, equaling 5.31 × 10−5 gdry cell weight ml−1 of suspension which corresponded to the 0.1 absorbance at λ = 550 nm.

A combined analysis of cell counts plus obtained weight/volume for each cell suspension (weight of tubes containing cell suspensions minus the weight of empty tubes) provided a percentage of the total population of cells that had invaded through fibronectin.