Sentence examples for weak particles from inspiring English sources

The RCAs were firstly coated with a layer of cement slag paste (CSP) to reinforce its weak particles.

Compaction parameters show a marked procedural dependency due to the particle morphology and weak particle strength of ash.

Thus, in addition to having low densities and magnetic field intensities the plasma within the expansion fan decelerates and exhibits weak particle fluxes.

These results suggested that two types of interactions contributed to the physical gelation in EP/POSS melts were present: the strong particle-to-particle interactions between the POSS crystals and the weak particle-to-matrix interactions between the POSS crystals and the EP matrix.

This suggests that weak particle aggregation may exist.

However, it was difficult to form dense films using small particles with weak particle-to-particle bonding as the starting powder [15].

As seen earlier, higher heat transfer rates are observed for longer period when particle fraction is more because of weak particle migration.

Therefore, it is considered that the impaction of ceramic particles is not sufficient for the densification of the BaTiO3 thin films on Cu substrates, and therefore, these BaTiO3 thin films have chinks and weak particle-to-particle bonding.

We explained the above results by concluding that the chinks and weak particle-to-particle bonding bring about leakage currents based on the relation between hardness and the electrical properties.

Consequently, we proposed that the chinks and weak particle-to-particle bonding in the BaTiO3 thin films with thicknesses of less than 0.5 μm on Cu substrates could be the main cause of the high leakage currents.

From the surface morphologies of the BaTiO3 films on Cu and SUS substrates, it was considered that the chinks and weak particle-to-particle bonding of the BaTiO3 thin films bring about an increase in the leakage currents.