Sentence examples for wavelength of the sample from inspiring English sources

UV vis analysis proved the wavelength of the sample to be 429 nm, resembling the surface resonance peak (SPR) specific for AgNPs.

Therefore, the response wavelength from QDs covered by AlAs blue-shifts compared to the response wavelength of the sample without AlAs layers.

After subsequent rinsing with PBS, ethanol and DI water, it is found that the LSPR peak returned to 579.5 nm, and further sonication made the average wavelength of the sample down to 575 nm, very close to the wavelength before BSA adsorption.

At a predetermined time, the residual dye concentration in the reaction mixture was analyzed by centrifuging the reaction mixture and then measuring the absorbance by UV visible spectroscopy of the supernatant at the maximum absorbance wavelength of the sample at 606 nm.

When we incubated the UV-exposed sample again with biotinylated thiol in ethanol, extinction intensity reduced, and wavelength of the sample's LSPR extinction peak returned to an even lower wavelength of 560 nm, because the streptavidin nearby the nanoholes were dragged away by excessive biotin in ethanol, and a new layer of biotin was anchored onto the sample.

The dependencies of the refraction coefficient on the wavelength of the samples can be seen in Figure 5. Also, the dependence of the refraction coefficient on the ZnS concentration was made and can be seen in Figure 6.

The absorption edge wavelength of the samples derived from HCl is shorter than that of the samples prepared with either HNO3 or HAc, which can be ascribed to their different crystal phase structures and the narrower band gap of rutile TiO2 (3.0 eV) compared with that of anatase (3.2 eV).

A wavelength scan of the sample was performed at 85 °C with the same settings as described above.

The values were presented as checksum K/S (the sum of K/S of all wavelengths of the samples spectra).

In the DR spectra, the LSPR wavelengths of the samples prepared with and without UV irradiation were 930 and 990 nm, respectively.

At the same time, in order to characterize the reproducibility in peak absorption wavelength of the new strategy, sample F was made a replicate of sample E. First, XRD tests were carried out, and Figure 2b,c were the results of samples grown by the two different strategies.