Sentence examples for washer surface from inspiring English sources

For exposures greater than 3 minutes it was difficult to detect any bacteria on the washer surface.

For exposures greater than 3 minutes, it was difficult to find any bacteria on the washers, and only scattered aggregates of material were visible on the washer surface.

The EPS appears to be removed after 1 minute of AMF exposure, although bacteria are still visible on the washer surface.

Fiber-optic measurements of the washer surface temperature during a 20 W exposure for 10 minutes (Fig. 2e, black squares) demonstrates a steady state temperature of approximately 90 °C (Fig. 2e).

When the bacteria adhered to the washer surface for 5 minutes, followed by culture in TSB for 0, 2, 4, and 8 hours for biofilm formation, BCRs on the washer surface were 4.1, 9.5, 37.0, and 79.2% in the 0 hr, 2 hr, 4 hr, and 8 hr groups, respectively, showing that BCR significantly increased with culture time in TSB).

After washing twice with phosphate-buffered saline (PBS) to eliminate floating bacteria, the washers with adherent bacteria were incubated in 1 mL of fresh TSB for 0, 2, 4, and 8 hours to allow the bacteria to form biofilm on the washer surface, being designated as 0 hr, 2 hr, 4 hr, and 8 hr groups, respectively.

After tibial graft fixation with an absorbable interference screw, tibial site fixation was reinforced with suture anchoring to a washer on the anterolateral surface of the tibia.

Colin Moynihan reports that workers were using power washers on the granite surface of the park: As the sun rose, people on their way to work began walking past the park, with some turning to glance at an empty expanse they had seen in two months.

Stress concentration was observed on the periphery of the contact surface between domed washer and plate, which is significantly influenced by the strength of domed washer and is considered to be 20%30%% higher than that of plate.

After a 1 minute AMF exposure, the biofilm matrix components are largely gone, however, the individual bacteria are still visible on the surface of the washer.

(e) Fiber-optic temperature measurements of the surface of the washer (squares) during a 10 minute AMF exposure show a steady increase in temperature until a steady state value is approached at 6 minutes.