Sentence examples for was approximated by multiplying from inspiring English sources

Mean blood velocity, Vb, was approximated by multiplying the centerline blood velocity by 0.625.

First, the area of activity in the primary auditory region was approximated by multiplying the medial-lateral extent with the dorsal-ventral extent.

The estimated risk associated with each point total in the 80+ score is shown in table 4. The estimated risk was computed using the formula described in the methods, where the ∑βχmean was calculated to 0.106842 and the ∑βχ was approximated by multiplying B with the points and adding back the base value for eGFR (−0.012×105 mL/min).

The axial phase velocity of the wave is approximated by multiplying the speed of light by the ratio of the pitch to the circumference of the helix.

Comparing the results of OAWCF for field sizes of 15 × 15 and 10 × 10 cm2 (Figures 2 and 3) with CFf.s for a 15 × 15-cm2 field size (Figure 4) under 6-MV photon irradiation, it can be deduced that an OAWCF at a non-reference field size is approximated by multiplying the given correction factor at a reference field size by the corresponding correction factor at a non-reference field size.

Time at risk is approximated by multiplying the mid-interval population (P) by the length of the interval Δ t.

In general, the effect of a given error on the results of meta-analysis can be approximated by multiplying the weight of a given study by the estimate of its relative error.

It states that the future value of an annuity whose percentage interest rate and number of payments multiply to be 72 can be approximated by multiplying the sum of the payments times 1.5.

The annual recovery rate from KP in each cohort was approximated by the rates of recovery from KP during the follow-up period multiplied by the estimated proportion of recoveries one year after baseline.

Far away from the origin, small lateral shifts of the impulse response can be approximated by simply multiplying the kernel by an appropriate pure linear phase.

This was then used to obtain the cross sectional moment of inertia required to calculate the stress values at failure according to the Euler-Bernoulli Beam Theory, where the peak stress as a result of bending can be approximated by the bending moment multiplied by the distance from the neutral axis to the outermost fibres divided by the second moment of area.