Sentence examples for was adjusted below from inspiring English sources

Moreover, pH effects on the diameter were a reversible procedure, and micelles could be recovered when pH was adjusted below 5.5 as shown in Fig. 4. Figure 6 shows TEM images of micelles prepared at pH 6.2 and 7. TEM pictures of copolymer micelles showed that the self-assembled micelles were well dispersed as individual micelles with spherical shapes at pH 6.2 (Fig. 6a).

Signal amplification was adjusted below visibility of noise and the focus immediately below the lesion.

The results obtained suggests these lamellar-like products dispersed near the fusion line in a Ni Mo Cr welded joint will not influence the joint's mechanical strength and stability while the peak temperature in the HAZ was adjusted below 1350 °C, providing valuable guideline in designing and applying the Ni Mo Cr system superalloys.

tACS-intensity was adjusted below individual phosphene- and discomfort threshold using a staircase procedure (see Supplementary Information) and ranged from 1.35 to 2 mA (peak-to-peak).

An 8 s pulse at a potential sufficient to drive the coupled redox reactions was applied ("on" state), followed by an 8 s period at which the potential was adjusted below the onset potential ("off" state).

However, several studies have shown that even when tracheal cuff pressure is adjusted below 30 cmH2O, ischemic tracheal lesions could still occur in patients intubated with high-volume low-pressure cuffs [47, 48].

The P3HT PCBM has the resistivity of about 103 Ω < cm [26] whereas that of a ZnO can <span class="lh lhl">be adjusted below 1 Ω < cm by solution-based method [27] or even below 10−3 Ω < cm by CVD or PVD deposition methods [28].

However, several studies have shown that even when tracheal cuff pressure is adjusted below 30 cmH2O, ischemic tracheal lesions could still occur in patients intubated with high-volume low-pressure cuffs [ 47, 48].

The nominal tip curvature radius was less than 10 nm; a spring constant of silicon cantilevers was 0.01 N/m; a resonance frequency was 285 kHz; the loading force was adjusted to below 1 ~ 2 nN.

Mascot score was recalculated by percolator function in the mascot for increasing sensitivity of correct identification and false discovery ratios (FDR) of the search results was adjusted to below 2%.

Water was circulated to a loading gauge, placed on a dry moisture reservoir, and connected to a water bath to keep the interface at 37° ± 0.5° C. The loading gauge and support surface was adjusted 23cm below the water bath level and the air flow through the interface initiated.