Sentence examples for voltage spectra from inspiring English sources

Open image in new window Fig. 6 Case 1: DC side voltage spectra.

Open image in new window Fig. 8 Case 3a: AC side current spectra Open image in new window Fig. 9 Case 3a: DC side voltage spectra.

It is observed that at sufficiently high ac current amplitudes even harmonics dominate in the pick-up voltage spectrum.

With analyzing all interference voltage spectrums on device's power line, the results of a statistical test are shown in Table 1.

This paper describes a noise test system, which was purposely developed to measure the noise voltage spectrum of CMOS devices in a frequency range extending up to 100 MHz.

The white component of the noise voltage spectrum, which is most important for fast signal processing, and the 1/f noise contribution are investigated to find low-noise design criteria concerning the choice of the polarity and of the channel length of the preamplifier input device in low-power operating conditions.

The resonant frequency of the sensor is detected remotely with one or a pair of loop antennas by measuring the impedance or voltage spectrum of the antenna(s), with the environmental parameters of interest then calculated from the measured resonant frequency.

A Fourier transform is performed on the measured output voltage and subjects the voltage spectrum to a 100 to 5000 Hz digital filter to reject unwanted noise outside the signal bandwidth.

Fig. 6 Differential conductance-versus-voltage spectra for a planar S-n-I-n-S junction with identical s-wave superconductors and high-transparency transition region (D I = 0.7) without n interlayer (α = 0) and for a finite thickness of the normal n interlayer.

Three phase or phase-segregated gas insulated switchgear (GIS) is now used over the complete medium and high-voltage spectrum.

The written bit exhibits a radius of approximately 5 nm, corresponding to 10 Tbit/in2 Fig. 16 a Current-voltage spectrum of amorphous GST thin film measured in the range of 0 10 V with C-AFM; b the corresponding resistance of the amorphous OFF state, amorphous ON state, and crystalline state.