Sentence examples for voltage conditioning from inspiring English sources

Moreover, during the commissioning of the injectors, and the high voltage conditioning of the beam source, the full beam power is dumped and measured on a calorimeter.

Since the electrical power output of a fuel cell stack is seldom at a suitable fixed voltage, conditioning circuits and their associated controllers must be incorporated in the design of the fuel cell power system.

In this paper, a complete control architecture is proposed for the voltage conditioning stage of a hybrid power generation system composed of a Stirling engine coupled with a supercapacitor.

Previous to the measurements, the mass spectrometer was checked using the OQ kit (BioRad) for high voltage conditioning, detector calibration, detector sensitivity, mass drift, mass resolution, and mass accuracy.

With a low intracellular chloride concentration (4 mM), chloride currents were elicited from the conditioning voltage at –95 mV by a series voltage steps between − 150 and + 150 mV (− 145 and + 215 mV for G190S) applied every 3 s in 10-mV intervals, followed by a step to − 105 mV (Fig. 2).

By plotting the conditioning voltage vs the peak current amplitude at −60 mV, we calculated that removal of inactivation had a V50 of 85.5 ± 5 mV (n = 10).

The hardware of the SmartID prototype is composed of a voltage transducer, some conditioning stages, a commercial μcontroller and an output stage.

To estimate the conditioning voltage when the subsequent peak Na+ current is half maximally inactivated, the data points can be fitted to the equation: (1) Here h∞ is the relative Na+ current, Vh is the voltage when the Na+ channels are half maximally inactivated (h∞ = 0.5) and kh is the steepness coefficient.

The first dimension was run on a Bio-Rad Protean IEF cell system (Bio-Rad, Munich, Germany) according to the manufacturer's instructions for the recommended voltage ramp protocol (conditioning step: 250 V for 15 min, voltage ramping to 10,000 V during 3 h).

Voltage-dependent inactivation properties were determined by applying conditioning, inactivating membrane voltage steps from a −80 mV holding potential to levels ranging from −130 to +10 mV in 10-mV steps (Figure 6 A).

The current rise time decreased and amplitude increased proportional to the voltage applied in the conditioning step.