Sentence examples for vibration value from inspiring English sources

The evaluation method, maximum transient vibration value as defined in ISO 2631-1 was found to be adequate in predicting vibration discomfort during a four second transient vibration exposure.

The first eigenfrequency (calculated in accordance with Eurocode 5) and Hu and Chui׳s criterion (calculated from measured quantities) proved to be the best indicators of vibration annoyance, and the Maximum Transient Vibration Value (computed on the basis of the accelerations experienced by the test subjects) to be the best indicator of vibration acceptability.

The most commonly used standards for predicting discomfort from WBV are BS6841 19877) and ISO2631-1 (1997) which offer different frequency weightings (Wband Wk) and three methods of assessment: vibration dose value (VDV), estimated VDV (eVDV) and maximum transient vibration value (MTVV).

The vibration values obtained from each bearing show that the main excessive vibration sources in the system stem from mechanical looseness and misalignment.

Machinery Directive 89/392/EEC and its amendments require that vibration measurements be made and values put into the instruction books if the whole body vibration values are greater than 0·5 m/s2.

The measured vibration values showed that technological instability (rotor clogging by fiber during combing and subsequent braking and speed deceleration, a signal from a damaged drive belt, variable dynamic imbalance of the rotor, and at the same time an uneven bowl wear caused by the fiber friction) had a noticeable impact.

The train starts from rest, accelerates to about 80 km/h during which point the vibration values rise above the comfort line.

Adeyeri et al. (2016) investigated the potential of using temperature and vibration models to monitor the performance of conventional machines, in which their functionalities are hampered by abnormal changes in temperature and vibration values.

As shown in Table 3, on April 16 , 2012 the vibration readings sampled from the production process revealed that the vibration values of the extruder gearbox, cutting machine gearbox and punching machine gearbox read 0.970, 0.980 and 0.360 mm/s, respectively.

When looking at a situation combing some or all of these factors, the perception of comfort based on similar vibration values may be judged as uncomfortable in a given environment and comfortable in another environment [20]; it also defines ride quality as an entity representing a passenger's judgement of comfort level of a specific journey based on all experiences encompassing all factors.

Shock-induced vibration values were not presented in Wolf et al. [ 10], but continuous vibration values are comparable between both studies.