Sentence examples for vent flow from inspiring English sources

QI, Qo = Process vent flow rate, dry standard cubic meter per minute, at a temperature of 20 °C, at the inlet and outlet of the control device, respectively.

Three operation parameters (vent time, vent flow and vent pressure) were optimised by applying a D-optimal experimental design.

Discrepancies are ascribed to the disturbance of the vent flow and stratification in the room by the wind.

Given the low vapor pressures of some cryogens, such as solid hydrogen, the vent flow from dewars used in space can enter the transitional and molecular flow regimes.

Preliminary analyses were also performed using the churn-turbulent vessel flow model and homogeneous equilibrium vent flow model of the SAFIRE code to elucidate the two- and three-phase venting characteristics.

In addition, the desorption step required the following conditions: 250 °C (desorption temperature), 15 min (desorption time), 14.1 psi (∼97.2 kPa) (vent pressure) and 75 mL min−1 (vent flow).

Group 2 process vent means a process vent for which the vent stream flow rate is less than 0.005 standard cubic meter per minute, the total organic HAP concentration is less than 50 parts per million by volume or the total resource effectiveness index value, calculated according to § 63.115, is greater than 1.0.

Group 1 process vent means a process vent for which the vent stream flow rate is greater than or equal to 0.005 standard cubic meter per minute, the total organic HAP concentration is greater than or equal to 50 parts per million by volume, and the total resource effectiveness index value, calculated according to § 63.115, is less than or equal to 1.0.

A coil heat exchanger, which is 3 m in length and 6.35 mm in outer diameter, and a fixed size orifice of which diameter is 0.4 mm are fabricated to remove heat from the stored fluid to the vented flow.

Oxygen exclusion experiments are performed in a pilot scale flow cell (2×1.1×0.1 m) using different venting flows and two different outflow boundary conditions (open and partially covered).

Construction of cones and depositing of tephra near the vent area, flow levees along channel margins, and elongated tumuli formed by flow inflation will all affect the routing of subsequent flows (e.g., Mattox et al., 1993; Wolfe, 1988; Dietterich et al., 2012; Elissondo et al., 2016).