Sentence examples for variation of reference from inspiring English sources

In order to demonstrate the abilities and robustness of the Variation of Reference Strategy several numerical examples considering different kind of materials are presented.

A 5-bit resistor trimming is used to compensate the variation of reference voltage due to layout mismatch and process variation.

The so-called Variation of Reference Strategy can be seen as an inverse approach, defining the nodal positions in the material configuration as design variables holding the spatial configuration fixed.

The variation of reference signals must be taken into consideration, and it is significant to investigate RadCom system with a single waveform.

After accounting for the effects of vapor pressure deficit (D) and solar radiation (R s)) on G si), much of the remaining variation of reference G si) (G siR)) was driven by that of leaf-specific hydraulic conductivity, which in turn was driven by that of A s /A l).

In the variation of reference as in statement 1, the study to compare the accuracy among Glu-ABGs, Gluco-C, and Gluco-A is essentially relevant.

Our review shows comparisons among devices and between hypo- and non-hypoglycemic ranges, as well as problems in studies including variation of references and insufficient data for a hypoglycemic range.

This controller is oriented to drive an AC DC converter operating in continuous mode with power factor near unity, and in order to improve static and dynamic performances with large variations of reference voltage and load.

This program determines the pairwise variation of a reference gene with all other reference genes and defines the reference gene-stability measure M as the average pairwise variation of a particular gene with all other reference genes.

Another source of variation of the reference equations published [ 9– 24] may be the use of different FeNO analysers or calibration procedures [ 50] or the method of measure (Medisoft versus NIOX) [ 45], even though all studies reported that they were following the ATS/ERS guidelines [ 1, 51].

Briefly, all analytes that passed QC checks based on the following four criteria (standard curve linearity, intra-assay coefficient of variation [CV], interassay coefficient of variation for reference sample, and percentage of missing data; Supplementary Material S4) were taken forward for further analysis.