Sentence examples for valve to be from inspiring English sources

Many surgeons consider the tricuspid valve to be a second-class structure.

This article presents the development of a microfluidic valve to be used in capillary flow microfluidic devices.

Such modeling has been applied to design a novel, high efficiency NMP valve to be used in a piezoelectric micropump.

For comparison purposes, the same modeling has been applied to a standard nozzle-diffuser NMP valve to be used with the same piezoelectric actuator.

The all-oxide architecture allowed the spin valve to be field annealed from a temperature above the high Néel point of BFO (∼660 K), after which a very large exchange bias field (Hex) was achieved at 5 K and kept at a decent value at room temperature.

Preoperative transthoracic echocardiography (TTE) revealed the aortic valve to be tricuspid, with a valve area of 0.57 cm [2], maximum flow rate of 5.0 m/s, maximum pressure gradient of 101 mmHg, and average pressure gradient of 64 mmHg.

As a result, devices employing these valves have limited portability in applications that require valves to be closed continuously.

Think of a wastewater treatment plant that requires valves to be opened and closed in specific sequence.

After the NEB approved the project in February, the city of Toronto asked for emergency shut-off valves to be installed on either side of waterways.

The doctors decided that her mitral valve ought to be replaced.

Doctors decided that the valve needed to be replaced to prevent further injury.