Sentence examples for values for the medium from inspiring English sources

Consistent with the S values for the medium versus large N p subsets, we also observed a positive coefficient for ln N p, i ( β 2 = 0.08 for Econ., 0.17 for Mgmt. Sci., and 0.10 for Nat./PNAS/Sci., each estimate statistically significant at the p = 0.01 level).

In addition, Matsuoka and Srere's reported estimates kinetic parameter values for the "medium" ACCOA concentration range (5 50 µM) are KmA = 5 µM, KmB = 4.5 µM, KmP = 39 µM, KmQ = 3 mM, KeA = 5 µM, and KeQ = 4.3 mM.

Villanueva at al. (2005) hypothesized that this lack of association may have been due to the fact that exposure concentrations were relatively low, with cutoff values for the medium and high exposure groups of 0.029 and 0.036 μg/L, respectively (Villanueva et al. 2005).

This model underestimates the recharge value for the medium rainfall values (p < 400 mm).

Thus, a threshold of 18 heads/km was considered to be a reasonable cutoff value for the medium density of small ruminants in this study.

Further studies on batch fermentation kinetics using the optimized values of the medium composition for K. marxianus NIRE-K1 and NIRE-K3 resulted in final ethanol concentration of 17.73 (86.27% of theoretical ethanol yield) and 19.01 g l−1 (94.12% of theoretical ethanol yield), respectively.

Median CO2 values for the low, medium, and high CO2 conditions were 600, 1,006, and 2,496 ppm (which we refer to as 600, 1,000, and 2,500 ppm), and ranges were 132, 92, and 125 ppm, respectively (Table 1).

Since Au colloids exhibited selectivity nearly 100% in the model reaction (as determined by HPLC), the conversion could be measured conveniently from the consumptions of NaOH, which was added during reaction to maintain a constant pH value for the reaction medium.

For both strains, the difference between the mean NIR value for the control (medium with no cells) and the respective antibiotic treated cells was highly significant (p<0.002) irrespective of the concentration used.

We set the fog density value to 0.1 for the medium visibility condition and 0.3 for the poor condition, in a range from 0 (full visibility) to 1 (no visibility).

28 30 Increased value for this medium in performance assessments may encourage its use.