Evaluating these values parallel to today's discourse, sustainable identity can be achieved by emphasizing especially the locality.
The Young's modulus and fracture toughness results showed highly anisotropic elastic behavior with relatively higher E and KIC (fracture toughness) values parallel to the coating surface due to the intrinsic lamellar structure of the plasma sprayed coatings.
As postulated at various substrate values, parallel lines with similar slope and variable intercepts were obtained.
These data support the notion that serial serum cholesterol values parallel clinical improvement or deterioration in critically ill trauma patients.
b Deformation of the foundation Table 6 PFC parameters of spread foundation Parameters Value Parallel-bond radius 1.0 Parallel-bond normal stiffness (Pa/m) 5.13 × 1012 Ratio of parallel-bond normal to shear contact stiffness 1.0 Particle radius (m) 0.06 Normal contact stiffness (Pa⋅m) 2.21 × 1013 Ratio of normal to shear contact stiffness 1.36.
In a 2005 speech at the Conference Board, Gary Pfeiffer, the company's chief financial officer, described how DuPont had enjoyed a 340percentt increase in share value paralleling a 60percentt reduction in its environmental footprint.
In this article, we use the complex-valued parallel factor analysis model (COMFAC) algorithm [17] for trilinear decomposition.
In version 2.0 a SIMD operation can operate on 16 (short) or 8 (integer) values in parallel in contrast to 4 values in version 1.0 [16] (Figure 3). Figure 3 SandBridge's SB3500 SDR platform with three Sandblaster Cores [40].
These values of strain coefficients are more than 3 times the values of parallel to the 111 crystallographic direction (~200 pm/V), as calculated from the coefficients of single crystalline piezoelectric tensor of BaTiO312 or reported from macroscopic measurements29.
At a scan rate of 100 mV/s, the slope of the decay was calculated to be 1.43 × 10 –2 a.u./s, whilst the slower scan rate (10 mV/s) induced a lower value of 1.01 × 10 –2 a.u./s, with consistently higher absorbance values in parallel over the same time scale.
substituting the measured values of d (220), ( {a}^{perp }={a}_{mathrm{epi}}^{perp }, ) and k = 2, l = 2, h = 0 into the equation, we obtain the values for ( {a}_{mathrm{epi}}^{parallel }. ) From this value, the parallel strain ( {e}^{parallel }=left({a}_{mathrm{epi}}^{parallel }-{a}_0right)/{a}_0 )can be calculated (Table 2).
