Sentence examples for value of the torque from inspiring English sources

The maximal value of the torque during experiments of 78Nm was recorded.

It is shown that when the load torque is reduced towards half the value of the torque at the stationary condition, water mass flow rate, rotational speed and output power tend towards infinity.

The value of the torque to shear ratio significantly affects the behavior of the inverted T-shaped beams in terms of cracking pattern; failure mode; strut angle of inclination; cracking and ultimate torque; post-cracking torsional rigidity; cracking and ultimate shear; flange and web stirrup strain.

This will allow us to clarify the relationships among the design of an implant, the value of the torque generated by the implant, and the compressive force to the bones.

The subject was then instructed to perform leg isometric contractions (that is, kicking against the dynamometer lever arm) held for 3 to 4 seconds, while the maximal value of the torque generated during the isometric contraction was recorded.

Now consider the dynamics for smaller values of the torque ((D < B)), taking into account the existence of solutions going monotonically to an equilibrium and (without loss of generality because of periodicity) restricting our interest to the intervals ([u_{S}, u_{S}+2pi]) or ([u_{U}, u_{U}+2pi]).

The movement would be stopped to make the specimen deformation recovered, once the sensor above or below the specimen reached any one of the control values of the torque and angle in the spinal movement process.

The peak value of the eccentric torque occurring during passive joint movements (Peak Eccentric Torque, PET) and the joint angle at which the eccentric torque begins to occur (Torque Threshold Angle, TTA) were measured.

For what concerns the optimality criterion, either the system energy consumption or the root-means square value of the actuator torque are taken into account.

The obtained output operational performance characteristics of this generator along with the acceptable peak value of the cogging torque demonstrate the success of the topology and the effectiveness of the design methodology.

The results showed that the influence of different turbulence models on the velocity field is less, on the pressure field is relatively large, and on the value of the total torque is much larger.