Sentence examples for value of reinforcement from inspiring English sources

Numerical nonlinear relationships and relative sensitivities between the four parameters that govern the time to corrosion initiation of reinforced concrete structures are determined, including chloride diffusion coefficient, chloride threshold value of reinforcement, concrete cover and surface chloride exposure condition.

Thickness of reinforcement plates had no obvious effect on out-of-plane flexural initial stiffness of SHS X-joints when the value of reinforcement plates to chord wall thickness ratio exceeds 1.0.

We show that larval Drosophila not only remember the value of reinforcement (How much?), but also its quality (What?).

During the tests, the values of reinforcement content, friction load and sliding distance were changed on the intervals (0%, 20%), (49 N, 169 N), (100 m, 1000 m), respectively.

The three values of reinforcement obtained for the middle distance between trees (0.5, 1.5, 2.5 normalised distances) follow similar trends, whereas the results at 1.25 and 1.75 normalised distances show inverse trends with higher root reinforcement for the 160 sph than the 210 and 237 sph.

It was shown that there exists some optimum values of reinforcement content and some optimum values of sliding distance which minimize the wear rates also weight losses of tested composites for some fixed values of friction load in the experimental region.

The third strain gauge that is referred to as SR3 measures the strain values of reinforcements at the bottom of the beam at mid-span.

The regression equations obtained from the software is validated using diagnosis plots and the optimized values of reinforcements are obtained using the desirability analysis.

If the allowable maximum flexural crack width is set to 0.40 and 0.50 mm under the various tensile stresses of the reinforcement (0.4f y and 0.6f y ), respectively, the corresponding curves for the limiting value of the reinforcement spacing considering can be obtained as shown in Fig. 4.

Also the average value of optimum reinforcement content minimizing the weight loss was found as 13%.

Because such stresses are dispersed throughout the matrix, this toughening mechanism would add to the value of steel reinforcement in the strengthening of concrete structures.