Sentence examples for vacuum drop from inspiring English sources
Differences were noted with vacuum drop between Vsystem and claw vacuum depending on the liner venting system, with short milk tube vented liners having the greater vacuum drop than mouthpiece chamber vented liners.
Moreover, minor double cluster attachment frequency and minor mean vacuum drop were observed in the same MF.
The vacuum drop along the axial direction of hollow fibers was noted, especially near to the vacuum suction opening.
The vacuum drop in the short milk tube during periods of high milk flow was less in the compensating vacuum than in the standard milking system (11 ± 1.1 vs. 15 ± 0.7 kPa).
The aim of this study was to assess the effect of different combinations of operating parameters of an automatic vacuum cutting device (LactoFlow®, Gea Farm Technologies, Bonn, Germany) on milking efficiency (milking duration and milk fractioning), milking routine (cluster falls and double cluster attachment) and mean vacuum drop.
The increase of both MF and DT showed higher values of mean vacuum drops in the two tests performed.
The aim of this study was to assess the effect of different combinations of operating parameters of two AVCDs (LactoFlow®-Dematron® of GeaFarm Technologies® and SG®-mm25® of DeLaval®) on milking efficiency (milking time and milk fractioning), milking routine (cluster falls and double cluster attachment) and mean vacuum drops.
To our best knowledge, we are unaware of any other publications devoted to the convergence analysis of this leap-frog explicit scheme for Maxwell's equations even in a simple medium, while our results for metamaterials automatically reduce to the standard Maxwell's equations in vacuum by dropping some terms resulting from the constitutive equations.
Following liquid phase exfoliation (LPE) films were made by two different methods, vacuum filtration and drop coating.
Temperature decreases of up to 6 °C and 4 °C were measured at a heat flux density of 1200 W/cm2 for the vacuum filtrated and drop coated films respectively.
This method is based on calculations of ballistic exchange in vacuum between the drop and the substrate surfaces combined with Auger spectroscopic analysis of the substrate surface.
