Sentence examples for uv power from inspiring English sources

For example, appreciable amounts of UV power, combined with resist sensitivity to this wavelength band, would decrease image contrast.

A Monte Carlo simulation aided artificial neural networks model was further developed to quantify the importance of O3 flow rate (40%), UV power (30%) and ultrasound power (30%).

The optimal atrazine removal rate (97.68%) was obtained at the conditions of 75 W UV power, 10.75 g h−1 O3 flow rate and 142.5 W ultrasound power.

Additionally, the device responsivity R s can be calculated from the following equation: R s = (I ph/P o A), where P o is the UV power density, A the active area, and I ph the response current.

Responsivity, defined as the ratio of the change of electrical current to the illuminated UV power, was calculated to be 1.66 × 104, 4.67 × 105, and 4.41 × 104(A/W) for the single TA nanoline, NB nanoline, and NR nanoline, respectively.

The illumination system described in this paper provides sufficient ultraviolet light (UV) power while causing practically no thermal effect on the aerosol chamber (temperature variation <0.005 °C at full UV illumination).

This paper is an attempt to survey the benefits of a well-designed photoreactor containing just 6 ultraviolet (UV) high power light emitting diodes (HPLEDs); the power and wavelength of each UV HPLED are 1 W and 365 nm, respectively, the latter being an efficient source for photocatalytic studies.

The device exhibited good photoresponse and spectral responsivity under ultraviolet (UV) illumination (power density 1.8 μW cm− 2) at 5 V bias voltage.

The significance of reaction parameters was shown as followed: UV light power > the number of TiO2-coated acrylic sheets > initial phenol concentration > H2O2 concentration.

It can be expected that the separation of photo-generated electron-hole pairs at the CuI/ZnO heterojunction is further promoted by simultaneously increasing UV illumination power and compressive strain.

Finally, the photocatalytic activity of both undoped and Cr-doped TiO2 films was carried out on a special organic pollutant (amido black) using a multi-UV lamp photo-reactor having a UV output power of 1.4 W and a maximum spectral intensity at 352 nm.